Proper usage for touchscreen connectors

Thank you very much for your interest in this article and for taking your time.
We would like to show you how to properly connect and unconnect a 4pin touchscreen cable to its connector while avoiding to damage your product.  This How-to applies to any product listed within the following requirements.

Requirements:

• Plastic Enclosure with PCB Exchange Kit
• MegaDisplay 3 Including Touchscreen
• MegaDisplay 4 Including Touchscreen
• MegaDisplay 7 with Bezel and Touchscreen
• MegaDisplay 7S Including Touchscreen
• 3.5" Touchscreen
• 7.0" Touchscreen

4pin Touchscreen Connector

Step 1: Removing a cable from its connector

1.1 Using the thumb and index finger, gently grab the black actuator on both its sides and pull it outwards parallel to the PCB as shown in the below image.  

1.2 Pull 4pin touchscreen cable straight out away from its connector.

Step 2: Pluging in the cable into its connector

Follow the previous steps in a reverse order and fashion.

2.1 Bring the 4pin touchscreen cable, parallel to the PCB, and into the opened connector.

2.2 With both index fingers holding the back of the connector, carefully push in the connector's black actuator in with both thumbs while ensuring that the cable remains perpendicular to the connector.

Congratulations!

You are now able to properly plug in and remove the 4pin touchscreen cable from its connector.